Igor Gaspar
patreon
SLA vs SLS 3D printing
🕑 Added 2024-11-23 08:50:36 +0000 UTCJust an early access to latest video. Also, the data is added to the summary table. Attached to this post. https://youtu.be/E6niY8MtkM4
Comments
KennyLogouts
sounds great, thank you!
Igor Gaspar
Hello, I have extremly a lot of work on my side (filaments, products waiting for the test). On summer I am planning to start with resin printing too and then I will test a lot of resin materials too.
KennyLogouts
Hello Igor, I just became a member, thank you for your work! If possible, I would be interested to get your take on more resin comparisons, specifically any of Henkel Loctite's engineering resins, I know resin is getting better but I'm not sure if it's ready for end use. As always, I suppose it depends on the use case. Thanks again!
Jan Höhl
Hello Igor, thanks for the comparison. Didn't think the resin could be stronger, I would have bet on the nylon to beat it hands down. I'm allways reluctant to use nylon (fdm printed) in my projects, because of the creeping issue. Would be interesting to see a comparison between aneahled and just "rested". Have a nice weekend!
