Joe Easton
patreon
New Update Incoming - Looking for Testers
🕑 Added 2021-08-06 18:32:29 +0000 UTCHere are the changes that have been made so far for the next update.
Changes:
- Added adjacent key colouring only mode, can be disabled in settings to re-enable all key colours.
- Fixed Stems button colour. Will now be deck colour for stems mode and the specified colour for the custom pads mode. Default is Green.
- Added option in settings to keep time text colour to white when track is ending. Enabled by default.
- Added 4 new waveform colour settings 19 to 22. RGB 3, RGB 4, Ultraviolet, Ultraviolet Inverted
- Fixed Stems Colour Indicator Alignment
I am still investigating issues with the D2, it should be sorted but I need a few people to test this version I have to see if it works with the D2. All files are now back to stock apart from the ones needed for the S4.
The update should be with you tomorrow hopefully. Then I will add all of the new features into the lite version.
Thanks,
Joe
Edit, I have attached the files only (no installer or guide) for v3.4 of the hack to the bottom of this post. Please give it a test if you run your S4 along with any other devices. Thanks.
Comments
Augusto Traverso
I have the same problem with the number 4 effects unit just like you. When loading a track it turns off. Solution ?
Joe Easton
Hi Tyson, Files seem to have changed since Traktor 3.5.0, the future versions of the lack will likely only be compatible with this version and above
x-tropic
If you use 4 FX Units, 1 \ 3 for the deck "A" and 2 \ 4 for a "B" deck, then when loading a track on the deck "B", FX Unit 4 reset its binding to deck "B". Also, I never succeeded normally set up work with the effects. Each time you press on the PAD, to activate the effect (slicer replace to fx), it will start cyclically to work the button 1 (RST) in the FX Unit. This is very clearly visible when using the "Single" mode in the FX Unit. Please Joe, pay attention to this problem with the effects. Button 1 in FX Unit is constantly in the cycle for an unknown reason. Please also add the opportunity so that in the LOOP mode it was possible to switch to ROLL Pads and the LOOP mode was not reset. Also, I really want a more debugged algorithm Jump Pads (in the same way as the "MOVE" parameter for the keyboard in the controller manager). In the current implementation, it is impossible to achieve the same speed of this function as on the keyboard.
Tyson Sell
I'm having issues with 3.3.1 as soon as I copy the qml files over traktor will not launch. I get a message that says major problem/ terminated.
