bigovereasy
patreon
Cassette keychain v2 📼
🕑 Added 2023-02-25 02:50:59 +0000 UTCHi everyone, I made a cassette, I'll attach it to this post.
I don't know what to call it, maybe “Cassette keychain double”.
Probably, there will be no special changes with this design, perhaps small changes with clearance (0.25mm in this version), and I will make a case.
This cassette was conceived earlier than the one with one reel.
Therefore, it is more correct v1 😛
The reels inside are printed in a different color of plastic. The color design turned out to be accidental.
I printed a blue sample and the reels didn't turn, I decided to press and the reels just popped out. At the same time, the body did not break. It was possible to insert the reels back, without much difficulty. So I printed two more reels in white.
As you can see, the reels are made in the form of gears.
it is better to print gears separately from the body. Silicone grease Glidex can also be used here. I inserted the reels from the edge to the center.
I repeated the procedure many times, the body did not deform, except that scratches from the gears appeared. Be careful, take care of your fingers) 👈
Make sure that the teeth enter
Btw, as in the first version of the keychain, you can find an Easter egg. If you break off the protection, you will see 🙂 on the back.
I was asked several times to make a box for “Mini Big Red Boots” 😬
I added this box to the "3dmodels" folder.
I came across SBS filament at home, bought 1kg, about 3 years ago, the color "ginger devil" 😈
I tried to print big boots, for the sake of interest. They have transparency, I don't know how to apply it, apparently good for creating a vase or nightlight, this color will come in handy for Halloween 🎃
The right boot in the photo, I treated with solvent
