Mark 2 Design
patreon
FDM Printing HYDRO-SLED Sheild
🕑 Added 2023-08-11 19:40:52 +0000 UTCThis is how we've oriented and supported the shield for printing on our CR10-V3. I had one failure because it came loose from the plate but have printed 6 or 7 successfully.
Comments
Ron Austin
That’s pretty cool. I’m going to see if I can replicate that little of supports.
Mark2Design
Yes, just as shown.
Ron Austin
Mark, did yours print only with those supports as shown? That’s pretty amazing! I may try that angled bottom.
