SingularityGames
patreon
Assembling Magnetic Hexes With the Hex Assembler
🕑 Added 2023-03-18 14:59:00 +0000 UTCHi all,
The Hex Assembler is ready to go!
This device helps add magnets to the hexes and press the two halves together. While its possible to add the magnets without it, the Hex Assembler makes the process easier and requires less dexterity.
There is a version for both the 1-inch and 1.5-inch hexes. Note: the Hex Assembler is only compatible with Singularity Hexes (with the corner cutouts), not the traditional hexes.
Check out the video at the top to see it in action.
The files for the Hex Assembler can be found in the Singularity Games Patron Drive -> Singularity Boards -> Magnetic Hex Board -> Hex Assembler folder.
In the folder you will find three files for the 1.5 inch assembler and three files for the 1 inch hex assembler as shown below:
The plunger has magnets embedded in it during printing:
For the full printing guide, head here: https://www.singularity.games/singularity-boards/magnetic-hex-board-print-guide#h.husiu5r4egg4
The printed parts:
Placing one half of the hex into the assembler:
Placing the magnets through the holes in the plate:
The magnets embedded in the plunger help keep the other magnets in place while assembling the hexes.
Placing the other half-hex on top:
Putting the plate over the two half-hexes:
The plunger helps evenly press the two half-hexes together:
The 1-inch hex assembler works the same way as the 1.5-inch version:
