PoisonApplePrints
patreon
Maleficent Funko Poster
🕑 Added 2024-08-10 22:11:04 +0000 UTCThe next of our Funko Hue Forge posters has now been added to the download post (link here)
I'm eventually planning on making all 6 of the designs below including a Dr. Facilier one which I'll have to make from scratch since it doesn't exist. Who do you want to see next??
Side note for our sellers, this is just a personal project so if you want to sell these you'll have to purchase a license from HueForge.
Instructions:
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm
The Model is 200x284.42mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm
Filaments Used:
PLA Silk Yellow Transmission Distance: 6.8
PLA Silk Black Transmission Distance: 0.6
PLA Gunmetal Silver Transmission Distance: 20
PLA Silk Dark Purple Transmission Distance: 0.5
PLA Silk White Transmission Distance: 0.5
Swap Instructions:
Start with Yellow
During printing on Bambu, once the black starts you can remove the yellow filament spool from the AMS unit and load the white spool in its place.
At layer #10 (0.52mm) swap to Black
At layer #18 (0.84mm) swap to Silver
At layer #28 (1.24mm) swap to Purple
At layer #40 (1.72mm) swap to White for the rest.
The colours are already pre setup for Bambu once its sliced, but for anyone printing on Prusa slicer, on the filament preview bar to the right, right click on the layer numbers listed above and add a pause so you can change the colours accordingly. Don't forget to switch to white for the top yellow!
Comments
RedQueen90
Oogie Boogie
Ayden Potter
Im putting a vote in for Oogie Boogie!
Michellylynn
Would love the Evil Queen or Oogie Boogie next. :)
