Blondihacks
patreon
Vise Stop - Models & Drawings
🕑 Added 2020-08-15 17:22:40 +0000 UTCHey Patrons! Attached here are the models and drawings for the vise stop I made in this week's video. These have also been added to the shared Patron drive where all the models and drawings live:
https://1drv.ms/f/s!AjEukTfa9GrpauR9ENcKu5q7Bhk
As always, remember that the link to the Patron drive changes every month, so don't bother bookmarking it. I put a new link here each month.
Comments
Jon Lloyd
I did... I need to watch it again! Thanks Quinn π
Blondihacks
For metric, I don't think O/U reamers are a thing. Instead, you buy them by tooling class for the fit you want. So, to get an RC2 (or H7 in metric) fit on a 6mm hole, you buy an H7 6mm reamer. I covered this a bit in my Fits & Tolerances video, if you happened to catch that.
Jon Lloyd
Enjoyed this video! Iβm trying to find under/over reamers. Iβm in Oz so Iβm all metric but I have 6, 8 & 10mm only. Found an imperial set on eBay but only $79 US...
Bruce Rose
Thank you, Quinn...Nice chips, as always.
Blondihacks
Thanks Dean! :-)
Dean Williams
Very nicely done, Blondi-Quinn. Just a comment on the way this casting was made, when you make a crankshaft out of solid stock, this it the same way you do it. It's so when you turn the long crank diameters between centers you do not warp the crank "throw" part, leaving you with a crooked crank. You are doing very well from my 30+ year reign :) of experience. See you on Youtube! Have a great weekend, and God Bless. Dean
