Dan
patreon
Flexi Factory Piggy Bank BONUS
🕑 Added 2023-11-27 23:47:57 +0000 UTCHi there!
This little bank should round out the piggy options that have often been requested the last few months.
As you can see from the second picture, I created a little screw plug on the bottom so you don't have to break it to get your stash. Just make sure you don't screw it on tight, it can get stuck.
Two versions: One with and one without the $ on the top :)
Printing tips vary for this particular model:
BONUS DOWNLOADS are HERE!!! https://www.patreon.com/posts/bonus-files-here-88548096
Recommend upping the top layers to 6 or 7 to avoid pillowing on the top of the back (bambu's default is 4, which is too low)
No issues on my other machines because the default top layers is already set higher.
Consider a lower layer height (.12), or a variable layer height, so that the top prints a little smoother. I used a variable layer height on the tops of these and it worked like a charm.
***Fun addition to this print is add some 3d printed coins. Quite a few options online, but members can also use the Flexi Factory Coin and scale to 23% to "fit through" the opening. I printed one at 30% and it it made for a nice display piece sticking out of the opening! Don't forget that one can be printed in multicolor with a simple color change on the layer, no AMS needed.
Happy Printing -Dan
Comments
Dan
No. None of my files ever need supports!
BambuP1S
Does this Piggy bank require supports?
Luke North
I can't speak on this exact print, but for threads in general, I use a modifier around the threads and slow all of the speeds down to 40-50mm/s.
Mr. J
Can anyone offer any tips on threaded pieces? I can't get the plug to screw in. I used .12 layer height....
