MysticMesh3D
patreon
Sitting Pumpkin Buddy (Hidden Legs)
🕑 Added 2022-10-08 14:08:37 +0000 UTCThis version of the Pumpkin Buddy has hidden legs! This 3D print is a fun halloween decoration/little accessory for your office setup that will bring good vibes!
Simply print one out, lift up to expose the legs, tilt back at an angle, and the Pumpkin Buddy is now chilling in a sitting position!
Printed at 0.2mm layer height
Comments
Gary Greer
I like the way you think lol
Mikael
Can you make it like a christmastree? :D It's so sweet.
Matthew Moscato
No supports needed!
Spencer Diniz
Are supports necessary?
Brandon Wieber
I would like to see the legs similar to the Zou ghost instead of the ball at the top of the leg since they can rotate 360 degrees. The ghost uses a square I think
Brandon Wieber
Printed this in flashforge flexible pla (TPU) and came out AMAZING
