MysticMesh3D
patreon
Stash Potion *Updated Fix*
🕑 Added 2023-06-12 01:07:28 +0000 UTCThere was an issue with the middle section of the stash potion not printing well. This was due to the angle at the bottom stash area of the middle connector & an issue with the end of the threads on the inner container.
Changes made:
- There is no longer an angle at the bottom stash area on the middle connector. This area now prints completely flat and the bridging will result in a much cleaner print.
- There was an issue with the bottom part of the threads not printing properly resulting in a small gap defect on the surface. Although the threads still worked as normal, this defect was ugly and needed to be fixed. This issue was fixed and the updated model will no longer have that problem.
The threads are still the same size and nothing has changed for the base of the potion or the lid. If you already printed those two pieces out, they will fit the same way on this updated middle connector piece. This updated model only features changes to the middle piece, the top and bottom are still the same.
I've updated the original stash potion listings with the updated model: StashPotionMiddle(Update).stl
Comments
Robin Benton
How would I go about making a mold for this part for Dab? I just don’t want it to stick to the PLA, any guidance would be greatly appreciated!
Matthew Moscato
I apologize I didn't catch this issue sooner. Your printer & slicer are fine :D
DaveH
Questioning*
DaveH
Thank you for this, I was question my slicer/printer.🤦♂️😆
SandBox3DPrintables
Thanks for the update!
Matthew Moscato
I apologize about this issue. It didn't become apparent to me until I printed out a 200% scaled potion and noticed something wasn't right. This new middle connector (StashPotionMiddle(Update).stl) will print correctly and you won't experience those same issues again.
Dogblock 3D
Yesterday I printed it out and I had the same problem
