MysticMesh3D patreon

Box Style Chest (Key Lock)

🕑 Added 2023-10-17 19:02:36 +0000 UTC

Comments

Barry Beach

I've tried starting this twice and always end up with all of the corners warping. I've used anti warp tabs but they don't help. Any other settings? I printed the first two at 180mm/s. Don't want to go any faster as it may warp even more. But if I get too low, I end up with a 24 hour print. Any suggestions?

Kyle Rogers

dont think it would be as durable in a 2 piece design the way the hinge is. the lid could be made shorter if you print that side with supports or if he designed supports in the model it self.

mikey roberts

im down to 6 hours but i am printing at 250mms, i could do 4 hours at 500mms but could effect the locking mechanism. i have an elegoo neptune 4 printer but depending on what printer you have you could be printing as little as 50mms. Increase your layer height slightly, maybe to .22 or .24. you should be able to print at around 60-70mms comfortably on a standard ender if its dialled in. i would reduce infill to 8% and infill type to lines as this would still give plenty strength. good luck :)

Hell Houndz Productions

anyone get this down any amount of significant time for print time? i got under 12 hours with 2 walls triangle 15% infill but havent printed yet to see