MysticMesh3D patreon

Stackable Mini Crate V2

🕑 Added 2023-10-24 03:12:21 +0000 UTC

Comments

Chris McCumber

Good evening, just wanted to reach out with a question but first wanted to say that your content is pretty awesome, Thank You. 1st question - Do you have any recommendations on making this print faster but keeping somewhat of the same quality?? I have the bambu P1P and it takes me around an hour to print one create. Is that normal ?

Jackyboy5221 Yes

does the inserts for the other crates fit in it

George Glasgow

If your using Cura or Creality software Go to Support then Support Placement and choose "Touching Buildplate" I adjusted my "Support Overhang Angle" to 80 this will still build a little support for the bottom of the handle but its the closest setting I found for "Print with supports on build plate only" setting thats in the Prusa Slicer

Jack Grafing

Is it possible to do supports like that in cura, I don’t use whatever software you are using

Matthew Moscato

I'll start designing Christmas models closer to December.

Matthew Moscato

If you rotate the model upside down then you'll need to use more supports for the top of the crate which will increase print time and material wasted. The best way to print this model is upright with supports on the build plate only.

3Dprintmates

Can i just rotate it upside down ?

Jackyboy5221 Yes

Could you start making Christmas 3d models

Matthew Moscato

You can scale these crates however big you’d like!

Jackyboy5221 Yes

Could you make a bigger stackable crate

Matthew Moscato

The inserts for the V1 model crate won't fit these V2 crates. These stackable crates aren't meant to have inserts as they wouldn't be able to stack if there was an insert inside.