badobsessionmotorsport
patreon
We suck - We're sorry.
🕑 Added 2022-12-20 13:40:32 +0000 UTC2022 hasn't panned out as we'd originally planned. We had booked the rolling road session for February, the car was meant to have been finished by spring and we'd be on our next project by now.
There have been mitigating circumstances but there are no excuses; we've not delivered. We're embarrassed by the lack of output. It wasn't for the lack of trying and had we known then what we know now, we'd have done things differently.
You patrons are literally our life blood and in your position I'd be pretty bloody annoyed at the lack of progress too.
On the plus side, the 3D printing PCB odyssey is almost at an end and as you can see from the picture, it's looking quite good. It works too, which is a plus. The switch pack has been tested and it verks. We're getting some expert assistance with the Arduino programming - it's a steep learning curve - and that's coming on quickly. The main 3 dial dash cluster is printing as I type this and with a bit of luck, the effect will be very cool.
We've collected more bits for the neglected Escargot, and we've got hold of some very important parts for the MG, but the mini is the absolute priority though and we're not resting until its done. Well maybe a little bit over Christmas, but not a lot.
So again we apologise, and for those who have stuck with us through this belcalmed period, thank you. We promise to better in 2023 - we have some exciting things coming.
We hope you have a lovely Christmas - don't get too sober.
Cheers,
Nik, Richard and Ben.
Comments
I'm interested to see how you did the solder printed PCB. I've got a cheap old 3d printer and was thinking of trying something like that with it. Stay true to your standards and don't let the bastards grind you down! You guys are the best show on Youtube IMO.
Munted
Ep by Easter a chance?
