OddWorks
patreon
the buster sword is complete!!!
🕑 Added 2019-12-21 17:18:58 +0000 UTC it is assembled!!!! after an insane amount of printing the Buster sword is finally ready to publish! this model has been actually quite a challenge to put together just for the sheer size of it! The overall length of the sword is 1.8 metres it's actually taller than me and because of that, there is a slight downside to the model is it cannot be held up horizontally by the handle which is a massive pain, the reason is down to the weight, I used 3 wooden broom handles for the main structural support for the Sword and this added quite a bit of weight, enough to basically stress the plastic too far, the sword might be better using the PVC pipe is the main structure instead of wooden broom handles but sadly I won't be able to test that myself so I'm publishing the sword with a bit of a caveat and that being Don't Hold the sword horizontally by the handle if you're planning to use it as a prop.
I would I'd like to thank my patrons for helping me complete this project, I wanted to do the Buster sword since I got into 3D printing and thanks to you guys I was able to, you guys are awesome XD
you can find the model here :D
https://www.thingiverse.com/thing:4058467
![Noah Productions [NP] from patreon](https://patrefans.com/kistorage/42432.jpg)
