tempestvr
patreon
3D Printable VESA Desk Mount
🕑 Added 2020-03-11 22:27:25 +0000 UTCHi Guys,
Some 3D print STLs for you in this update.
This is a 3D-printable stand that will allow you to mount your OSR2 to a desk or table. It has three mounting positions and can be used either way up, which should give you a lot of height options.
You should use it with a couple of hex-headed M6 bolts (like the ones used for the OSR3) and a couple of M6 wingnuts. The bolt length should be the thickness of the table plus 10mm.
I recommend that you also invest in a set of anti-vibration mounts, which I have pictured above. They are really effective at preventing any noise from the servos being amplified by whatever you have attached your clamp to. I got mine from ebay for the equivalent of a few dollars. They screw in and sit between your OSR2 and the mount, so sure the ones you buy are the same size as the mounting bolts you are using (M4).
Enjoy!
Comments
M0$@ic
Sorry for the late reply here, in case this helps anyone. I have updated the information on my site to reflect that I use a thicker clamp to accommodate thinner desks. This is why the longer bolt length is needed.
anonymousbrah
so I bought this premade from MOSAIC with an OSR2, turns out the M6 bolt length needs to actually be larger than 10mm difference, probably best to get something like 30-40mm larger than the thickness of the table... I got one exactly 10mm larger and it's too small..
MpMan
hi, can you show a picture with osr2? will create as well a mount for use in bed ?
