TidyPrints
patreon
So, my old case broke.
🕑 Added 2022-04-06 05:31:00 +0000 UTCTabs rolled over too much to stay retained. I could have put a screw through the twist ring into the case, but eh....
Anyway, it's got a built in axial twist servo, heater compartments, and wire routing. obviously there's no need for so much wire in there, but i haven't cut the stuff to length or combined them yet, and it's a good example of it's capacity. that's two of the polyamide heating pads from adafruit, and a DS18B20 temp sensor, with a DS3235SG 270 on the end because it's the only 270 I have.
Reasonably sure I know how to finish this one up, I've got no idea if it'll be good enough to continue developing but only way to know is to try.
Comments
TidyPrints
Once it's ready I definitely will be!
nonaak
Do you want to share the stl files maby?
