TidyPrints
patreon
Even more case pictures.
🕑 Added 2022-06-22 09:07:48 +0000 UTCIt's now assembled, I don't have a full connector solution yet other than soldering and crimping, but it's not difficult stuff.
Picture 1 is the lube attachment, the tubing bends inwards and connects at the top of the case.
Picture 2 is the lube attachment inside the end of the sleeve. It's a loose fit both against the sleeve and between tubing and plastic to try and prevent it from sealing. May need to do more.
Picture 3 is the silicone tube inside the case going over the 4mm ptfe tubing.
Picture 4 is accidentally the stabby guy from Futurama, but also a cover that holds the silicone tubing tight against the ptfe. I should probably put a zip tie hole in this.
Picture 5 is the heater core after aluminum tape wrapping. It's really easy to use and spreads out the heat well. You can use little tabs of it to mount the thermal sensor or heaters, then fill in with other pieces. You can just smooth it out until it's a decently smooth surface
Picture 6 is wiring bundle coming out of the back, with everything installed. 30awg for vibration motors, 26awg for heaters, stock (feels like 26 or 28 awg) wire on the DS18B20 sensor. 4mm OD PTFE tubing for lube into a connector, both of which are pretty standard printer bowden stuff.
Picture 7 is of some 2 slot wago holes I put into the "upper" part with slots that reach into the main wiring area.
