TidyPrints
patreon
SSR1 Tensioner and VESA mount
🕑 Added 2023-03-30 04:12:04 +0000 UTCHey y'all, I'm planning on being a bit more active here in the future, yay!
Here's two parts I threw together and remixed with Tempest's originals to address some early needs I've seen people have: belt tensioning and mounting.
Tensioner:
Replaces the stock Idler and Spine Top to allow approximately 10mm of tensioner adjustment on the belt.
Uses:
2 M3 nuts
2 countersink flat head m3 x 20mm-25mm as needed, other m3 will work but won't be flat on top
Tighten it only enough to get smooth movement without belt skipping, overtightening may damage parts. Alternate tightening the screws so the part sits even in the channel. Nut pockets might be tight, soldering iron inserts them well.
VESA Mount:
Adapter for a 100mm vesa mount to the 44mm x 50mm holes on the SSR1. Uses 4x 20mm M4 to mount to the SSR1, and 4 M4 nuts to connect to your M4 screws via 100x100mm vesa. Meant for use with the case but should work fine without it too. Zip tie slots for wire management etc included. No supports needed due to bridging geometry on the recessed screw holes.
