TidyPrints
patreon
AGFRC A11CLS T-Valve Cap
🕑 Added 2021-10-04 03:53:27 +0000 UTCNOTE: Print the spacer to bring your A11CLS back to parallel, this servo's spline is 2.55mm below the stock SG90 spline.
Quick little part mod as I get my workshop redone, if you've got an AGFRC A11CLS micro servo, this has 24mm center to center mounting holes to allow you to use it with your valve. Works with all other stock valve parts.
Note: this release version uses the open source comic sans-alike font Comic Neue. Thanks for Yollio for bringing this incredibly important detail to my attention. Details on the Open Font License are available here: https://scripts.sil.org/cms/scripts/page.php?site_id=nrsi&id=OFL
(The above is 100% shitposting because I thought it was funny)
