UncleJessy
patreon
They said it couldn’t be done 🤣😂🥶
🕑 Added 2022-01-22 22:16:28 +0000 UTCResin 3D Printing outside in the snow 26f out 🤣😂🤘
Should have a video up tomorrow on this dumbass project I had to try
Comments
jillatized
lol I did not notice the heater at first
Carlo Krun
very interesting. after reading the other comments i dont think the camera would be an issue since i am a scuba diver and taking a good camera down in very cold water in a case isn't effected by extreme cold. but like Jonah asked: how long the resin sat in the cold before use AND how long after pouring did it stay out in the cold before and during the print. Also: as ive only used a couple manufacturers of resin, would/could some resins be more susceptible to cold than others?
Uncle Jessy
Yeah I might be cheating 😂
Uncle Jessy
I did capture the temp of the resin before printing outside
Uncle Jessy
Haha you and me both, it’s inside
The3DHobbyist
And to think I have issues at the 60° my basement gets this time of year
Jona Smith
Interesting project. Couple of questions I hope you can answer on your video tomorrow. How long was the resin exposed to the cold prior to pouring into the vat and before you started the printing?
Mark Morgan
I am more worried about your camera then the printer.
