UncleJessy
patreon
Quick 3D Printed Mold Box!
🕑 Added 2022-12-13 00:55:48 +0000 UTCTime to pour some silicone while the other box prints! 2nd was sliced in Prusa slicer with ironing on and .1 layer and is going to take about 10 hrs to print 🤮
Comments
Michael Tharme
Not a bad job, though, if that's a full print, I have a sneaking suspicion that the silicone might be really troublesome to remove with the walls and the undercut of the skull. I might be wrong though, only one way to find out... If you can, try use a 1:1 mix ratio silicone mix, trust me its less of a headache than working out percentages and ratios haha
Jeremy Davis
Looking good so far.
