UncleJessy
patreon
3D Printing my own $2,500 Airless Basketball... sorta
🕑 Added 2024-03-08 14:32:25 +0000 UTCThis video was way too much fun. Also, note to self, when you buy a new wireless mic make sure to test it for more than 5 minutes before jumping into a video recording. I didnt realize it was so bad. Will be futzing with that later today after I clean up all of the broken basketball bits
I'd definitely recommend printing one of these in a Flexible PLA or that Super PLA from overture. So much fun
Comments
G. Michael Bridge
Try some Shore 60D filament, it is a lot firmer than the Shore A stuff.
Randy Allman
Wondering if PA or PA-CF would increase Bounce and durability?
Paul Burtsell
nice work as always, any time frame on sharing the n4m max profiles you talked about in your last few posts like .32 or the petg???
Marshall Woodworks
The only thing holding me back from printing one was waiting for you to make a video about it. I think I'll need some more filament. Thanks for the rundown!
Javier Bermudez
I have to get started on mine
