ThinAir3D
patreon
1/4"-20 Attachment for Thingy Mount Now Available!
🕑 Added 2022-07-06 00:37:19 +0000 UTCHey everyone,
Here is another attachment for the Thingy Mount that was highly requested, the 1/4"-20. This attachment prints in 2 pieces, and requires a 1/4"-20 x 1/2" long hex head bolt, and works for most webcams and many other camera and phone attachments.
I have updated the printing instructions in the archives for the Thingy Mount and uploaded the STL's to the drive. You should be able to find the 1/4" bolt at your local hardware store, but I have also included a link to purchase on McMaster Carr.
As far as other attachments, I'm currently working on getting ahold of a Wyze Cam and hopefully a Mintion cam so I can make those attachments. Any other cameras that I want to make attachments for I will either have to purchase, or maybe get some help from anyone that owns them with measurements.
One thing I wanted to note: This attachment DOES work for DSLR cameras, but I don't advertise it as such or recommend using it for them because the mount itself is likely not strong enough. Unless you use one arm instead of two, but even then I wouldn't fully trust it.
I will be making a beefier version of this entire mount to accommodate larger devices like DSLR's and iPads in the near future, so stay tuned for that!
As always, I very much appreciate all the support and hope you like the new attachment!
- Jacob
Comments
Engrave Printing
For other suggestions, and this could be a bit too niche to make it worthwhile, but would love a holder for streamdecks (normal & XL). I film at sports venues, and if live streaming use a streamdeck to help with OBS. To have it clamped in front of me would be ideal.
Engrave Printing
this is just what i needed - thanks for this. Now just need my Bambu to turn up and i can print it.
