ThinAir3D
patreon
SNB2 Update!
🕑 Added 2022-08-26 23:50:02 +0000 UTCHey everyone!
Thank you all for you feedback on SNB2, I'm very glad a lot of you like the model! I've made a few updates/added some new STL's to help with the printing process for those of you that don't have multi-material setups. You can watch the 5 min video above to see all of the changes, but here are the cliffnotes:
1) Made a minor fix to the drawer. The STL has been replaced in the archives.
2) Changes magnet slots, reduced from 6 slot to 3.
3) New STL's uploaded for the Faceplate and Backpack. You can now print the eyes and the 'SNB2' plate separately and glue into place afterwards.
4) USB Slots! There are now 6 USB slots incorporated into the back of the legs.
You can find the new files in the archives already.
Again, I really appreciate the feedback and welcome any other suggestions! I've got a few other cool plans for Snib, and a couple other Desktop Bots in the works!
As always, thank you all for the support!
- Jacob
Comments
ThinAir3D
That means you're likely over-extruding if the parts are too tight. There is ample clearance. I would suggest checking esteps/flow
Engrave Printing
hi. Any advise - printed this, but the connections were way to tight - needed a hammer to get them to fit together, which obviously isn't right - and risk damaging the prints.
ThinAir3D
Why wait for the bambu!? haha
Engrave Printing
can wait for my bambu to arrive to start printing these
