ThinAir3D
patreon
Christmas Lightbulb Ornament/Container
🕑 Added 2023-12-02 18:13:38 +0000 UTCHey everyone!
This is the Christmas Lightbulb Ornament/Container. This design prints in 2, support-free pieces that thread together afterwards. The cap has a hole cut through so you can route thread through for hanging!
The "lightbulb" portion is hollow, with an opening of about 30mm so it can be stuffed with small candy or other things. The entire design prints in about an hour on my Bambu printers!
You can find the STL's and print instructions attached to this post, as well as in the Google Drive Archives!
As always, thank you all very much for the support and I hope you enjoy this model!
- Jacob
Comments
Christopher Kirby
Well count me in as excited!
ThinAir3D
Funny you mention that... I'm actually working on 2 different fidgets right now, one of which is a gyro fidget. With the gyro i'm really just fine tuning/tweaking to get the beste spin possible
Christopher Kirby
You should do some more fidgets! I use the bolts for purge, but want a really good gyro fidget to purge.
StarlightFoundry
Sorry ended up reading your PDF and it says it will scale up and thread just fine. That was my concern
ThinAir3D
Do you mean what size to scale it at? I'm confused
StarlightFoundry
Suggestions on scaling it to full print bed size?
StarlightFoundry
Ha! I have literally just been looking for light bulb things!!!
