STLMiniatures
patreon
Skeletons Updated
🕑 Added 2023-01-27 10:42:53 +0000 UTCHello to all of you!
We have just updated the skeleton models so that the legs don't break so easily when removing the supports.
We have modified the 3d models and the Atlas guys have put the supports back on them, they have told us to remind you that if you use hot water when removing the supports you can minimize the breakage a lot.
The models that have been modified are Skeleton Modular A, Skeleton Modular B and Skeleton Modular C (the Skeleton_Set also has the updated models).
You have everything uploaded to Sync, Google Drive and MMF.
Thank you very much to all of you!
Comments
Thank you! Appreciate the extra time and effort! I am unable to locate the updated files however. It says they are in sync and google but I don't see them. And using the prior link to SYNC the password for this current month doesn't work. The files on MMF show as the original files.
Jacob Decker
Thank you so much! I just figured out I was putting too much pressure on my build plate and other mistakes. This is a fun hobby, but so many variables to account for. Thank you for taking the time to increase my success rate.
Mark Mulligan
How long to get setup once you join
Tabletop_Blacksmith
I appreciate the additonal time you put into them! :-)
John Carnell
Every time i see a patreon "We made skeletons" I think, no you didn't you made a waste of resin! The entire nature of a skeleton means you have the smallest possible cross-section with the least amount of contact. A recipe for failure, hot water is not an acceptable solution for a multitude of reasons not least contaminating the water supply on disposal!
