itsartflex
patreon
Halloween Pack (October Model)
🕑 Added 2022-10-10 20:18:32 +0000 UTCThis model is now available at the below link at a small price
https://cults3d.com/en/users/ArtFlex/creations
The Halloween Pack Toys
This Flexi Skeleton is an articulated print-in-place model that prints without support.
There are 5 Models To print all week.
1. Flexible Skeleton
2. Skull
3. Pumpkin
4. Coffin
5 Magic Tub
The model is tested a lot and it is good to print without support without any worry.
-----------------------------------------------------------------------------------------
Artflex designs are protected by law and you are not allowed to sell digital files on any platform.
-----------------------------------------------------------------------------------------
Print Settings
No Supports
15-20 infills
3-4 Wall count
Downscaling is not recommended, however, if you are an expert you can play with it.
------------------------
Update - 21/11/2022
Added fresh files (Received feedback about files are nod loading in PRUSASlicer)
1.Artflex_Halloween_Pack.zip
2.Artflex_Halloween_Pack_3MF.zip
Comments
Fernando Pena
All good now! Appreciate it!
Hi, Files are loading fine in my Cura, However, I have uploaded the new files, Can you please re-check loading them again?
Fernando Pena
PRUSASlicer cannot load half the files???
Definitely, I will add the hanging hole on top of the skull and ping you soon
filharvey
Can you possibly add a hole or a way to hang the skeleton from his skull?
