itsartflex
patreon
Toon_Viper_Snake (December Model) (Archived)
🕑 Added 2022-12-29 20:41:20 +0000 UTCHello Everyone
I am Super excited to share the final design. I did minor changes to the design so Please get the latest Files.
Downscaled the Ball joint length a bit, Flattened the head bottom area a bit.
Keep in mind the below settings before slicing.
1. Use good adhesion with bed ( I lost around 2 prints Bcz of poor Bed adhesion of my printer)
2. Downscaling is not recommended However 20% Should be Fine (100>80)
3. Infiless is not necessary on the body but keep at least 3 wall count. 4 Bottom Layers 8 top layers.
4. Head requires infiles 8-10%, 3 wall count.
5. Speed as per your requirement and your printer.
6. PLA works well
By the way, I am out of filament now and planning to post this on Cults3D next week.
If you can please help me by sending some Beauty shots of your print.
Videos or Photos (Daylight or Sunlight to get perfect shots)
Thank you Everyone for supporting me. I really appreciate it.
Happy 3D Printing........................
---------------------------------------
Music Artist -kontekstmusic from SoundCloud
Music Used in this Video under Creative Commons License
Link - https://soundcloud.com/kontekstmusic/when-others-go-to-bed
