itsartflex
patreon
Flexi Baby Shark (Feb Design) (Archived)
🕑 Added 2023-02-18 14:55:17 +0000 UTCUpdate - 22-02-2023
Hello Everyone,
Received feedback from our community member that the Bambu Lab printers was not able to print at high speed because of the steep overhangs of the model. However, at normal speed, the model was printing fine as I have tested 5-6 iterations on my Enders.
Keeping overhangs in mind I have added another version of this model that has less steep angles (Overhangs) I hope this updated Design will work fine.
If you still facing any issues never hesitate to reach out to me.
Suggested Setting Below
Wall count - 3 minimum
Infills - 12% (Gyroid)
Layer height - 0.16mm to 0.18mm
Top layers - 8
Bottom Layers - 6
Top/Bottom Speed - 60mm/Sec
Speed as per Ender or similar machines - 30mm/sec outer wall 60mm/sec inner wall
---------------------------------------
Hello Everyone,
Here we go with the final version of our New model Flexi Baby Shark
This is a print-in-place model and prints without supports.
Remember to print at least 3 wall counts and 8 top layers.
I hope you will love this cutie 😄
Comments
Laying Layers
Adorable! Can't wait to get this on a printer!
