itsartflex
patreon
Flexi-Halloween-Bat (September Design)
🕑 Added 2023-09-04 19:39:56 +0000 UTCHello Everyone!
I am super excited to share this Articulated Flexi Bat that flaps its wings with the help of a rubber band. It hangs from a wire through its twisted feet and can stand on its feet and tail with a bit of balancing.
Please use the 'Rubber-Band-Insert' STL file to pass the rubber band through the holes on the back side of the wings. Alternatively, you can use some wire to insert the rubber band through the holes.
As usual, I have prepared a pre-painted file as well as a stacked version that is downscaled to 75%. Please do not downscale any further! Please avoid brittle filaments, especially on the downscaled version.
Rubber Band used, Below are some links
https://amzn.eu/d/0hy6YWx
https://amzn.eu/d/iesiszh
Suggested settings:
- Support free design
- Layer height: 0.18mm
- Wall count: 3
- Bottom: 4
- Top: 5
- Use the outer brim for better layer adhesion
- Infills 15%
Happy 3D printing!
Link to Download Post - ---------------September Designs-------------
Comments
Thank you :) The Parasaurolophus is now available at MMF mmf.io/o/318130
This is so cute! Sad I missed the Parasaurolophus. Will it be available for purchase?
Cedric (SideQuest3D)
going on the printer.
