itsartflex
patreon
ArtFlex-Flexi-Broccolis!
🕑 Added 2023-10-06 18:09:21 +0000 UTCGreetings, everyone!
Allow me to introduce the new design, Flexi Broccolis! (I'm not sure if this counts as a Halloween design, but it's certainly fun!) I've also added a keychain version,
I hope you'll enjoy printing it!
To ensure the best results, please follow these suggested settings:
- Support-free design
- Layer height: 0.16mm
- Wall count: 2
- Bottom layers: 5
- Top layers: 6
- Infill: 10% (Gyroid)
Happy 3D printing!
Warm regards,
ArtFlex
---------------------- Link to Download Post ----------------------
Comments
Is that hole after the print or in the Slicer view? Can you please share image on Instagram DM https://www.instagram.com/itsartflex/
Kelly H
Hey- just wanted to add on from Christian printing at .16 I’m finding there is a small hole in the centre of the mouth
Thank you for reporting, I just checked and it is causing the issue in multicolor while painting inside the month, I will fix that and re-upload it soon!
even at 0.16 layer the mouth is only 1 layer thick. maybe you can make it a little bit thicker?
