Inheritance Machining
patreon
(AD FREE) Some STYLISH Hold Down Clamps
🕑 Added 2023-05-11 14:00:04 +0000 UTCThis week I'm tying up a bit of a loose end and finally making a set of hold down clamps for the fixture plate. Never mind the fact that I have yet to actually use use the fixture plate... but I do have another project coming up that could also use some hold downs. So this is a "twofer" of sorts. And if I'm going to spend the time making them, might as well go the fancy route.
Comments
Brandon Sander
Nice! I think with a CNC setup you might find more use for the fixture plate than I have so far. Making these clamps was the first time I actually used it 😂
Brandon Sander
Thanks, Jeffrey!
Sean Harrington
The fixture plate and clamps are the first project I have planned for the Bridgeport cnc I have coming.
Jeffrey Spoor
another great episode Brandon, thanks as always!
