Williams Industries
patreon
Super Mario Wall Art
🕑 Added 2023-07-08 16:37:15 +0000 UTCHere is the wall art drop yall. Remember, face down on the build plate. Matte PLA and textured PEI plate works best. I have these settings set as I have found them optimal, but depending on your ambient temps, plate, and PLA, you may need to make some adjustments. For the depth, I would not go much less than 8m, I like 10 best, but up to you. If you change the solid paint layer, just make sure you do not go too low to the plate, otherwise you will have first layer issues. You can take the other Super Mario prints I added previously and mimic these settings to use as wall art as well.
Also, below is the link for the mounts that I use, just screw them in gently and you will be good.
Also, you can always shrink this down and add a magnet to the back, I typically do that and I am able to sell a decent amount of them that way. If you do a magnet, I suggest doing 100% infill.
I hope yall enjoy these! As always, appreciate all of you!
Hanging mounts: https://www.amazon.com/gp/product/B07Z4GJHGQ/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
