Grégoire Saunier
patreon
Future Y stepper mount?
🕑 Added 2019-08-07 13:34:47 +0000 UTCThis could be the future Y stepper mount. Much more stiffer and the stepper does not touch anymore the extrusion (on MK3). Doing some testing with this one right now. It will still probably need an extra support for the motor, will see what tests are going to say.
Hardware:
- 1x M5x12mm
- 1x M5x16mm
- 2x t-nuts
- 3x M3x18mm
Comments
Grégoire Saunier
Give me one or two days and will be good. Several changes have been added and I am finishing version for MK2S/2.5(S) on both Full Bear MK3 and MK2S/2.5(S) frame. I had to go in my cave for almost a week, that was not easy!
Nicolas Pottier
Curious as to whether this is at a point you are comfortable sharing STLs for yet! I'm at the point of building my Y carriage and I have the new idler printed but not positive that will work with the old Y motor mount. Happy to beta test this one too!
Grégoire Saunier
We can try the live stream, I would really like to have Patreons interacting with me. I have to find a good mic and research a bit on how to setup a live stream. Oh and my internet connection is quite unstable at the moment :D, should bet better soon hopefully!
Nicolas Pottier
Hey if it isn't something you enjoy then don't do it for sure. Patreon isn't a job and I for one am happy to support you with what you do already. Just something I have personal interest in. If you did a live vid chat though I'm sure your Patreons would be well behaved. :)
