Grégoire Saunier
patreon
New Z Tops
🕑 Added 2019-10-06 17:21:15 +0000 UTCHere is a view of what the new Z tops will looks like.
- Both M5 screws are now in front to allow better alignment and improve print quality (reduce warping).
- Stiffer holding of the Z smooth rod thanks to deeper hole.
- Several improvement in the geometry to improve stiffness.
- More precise surface to improve accuracy when X axis is ramming into Z tops.
Comments
Grégoire Saunier
No because then you become dependent on the length of the extrusion and the angle of the cut. Both are very hard to get perfect because extrusion is melted aluminum and so it wraps, twist and shrink exactly like our printed parts. The Z smooth rods are more accurate than extrusions and so they are the best reference to use.
Kyle Rothrock
Have you thought about incorporating the cap into this piece?
Joel Weinberg
So cool! When this is released, I'm going to buy the extended Z kit from All3D Makers.
