Grégoire Saunier
patreon
Oups ... little delay
🕑 Added 2022-02-18 14:51:01 +0000 UTCWe have found a potential issue on the extruder, nothing that cannot be solved, and we prefer to check before sharing with you. We will not be able to share before next week unfortunately.
I have added a section regarding 602 issue in the post "BearExxa V2 - Gearing" here: https://www.patreon.com/posts/62425637 .
Do you have any questions regarding the extruder? Feel free to ask!
(emoji by https://openmoji.org , open source emoticon library)
Comments
Grégoire Saunier
Genuine Bondtech ones (this is what we used for development and testing as well). This is a very important part, tolerances are tiny so you don't want to have something random there. Our delay is actually due to tolerance between those two gears actually.
Matthew Humphrey
Question about the extruder: Do you have any suggested sources for the additional gears we need?
Grégoire Saunier
Yes we have identified the issue and testing the improvement we made. This was an interesting one, I will write a post once we have finished the tests. I am glad we saw it before the launch.
Emeric Bréhaut
Is the problem solving going the good way ? :)
