Lowell's Fish Lab
patreon
Replacement Stand for Ziss Hatchery
🕑 Added 2023-10-17 02:04:15 +0000 UTCAfter a couple of months of testing, I think the "frustration free" Ziss hatchery stand is ready to venture out in the world.
I have included four height variants between 7 and 10 inches (original was 8in), along with a second set with a greater angle on the feet for printers that might struggle with the overhang.
This model prints upside down as shown in the image above. This was the best orientation I could find to print this as a single part. I know the overhang seems like an aggressive angle, but it has been no trouble on an Ender 3 when printed at or around these settings:
0.2mm layer height
30% infill density
1.0-1.2mm wall thickness (slightly better quality at 1.0mm for me)
25mm/s wall speed
35mm/s infill speed
I always err on the side of slower print speeds but for these tall, thin columns and ambitious overhangs, I suspect it will be very helpful to slow things down. Let me know how it works for you.
Enjoy!
Comments
Konjuring, Ink.
sir... can you PLEASE make this look like an AT-AT?! ffs Lowell!
Konjuring, Ink.
I love it, thank you....
