Filament's Folly
patreon
Kanto Region Gym Badges
🕑 Added 2023-01-20 01:03:43 +0000 UTCI lied, I said I would only do 5.... but there are 8 badges for Kanto, so I did them all and even added a pokeball one too. These have recess in the back for pins (Magnet ones listed below)
These should print fine in resin and FDM
No supports on FDM
Resin angle at 45 and light supports.
Now off to find more uses for these.
Comments
Kenneth Loebenberg
I am working on a case for these, It will be my next design after the ornamental metagross
Josh
these are sick Ken, would it be possible to make an open/closing case like ash carried to print all the badges, put them in their respective slots and angle the door backwards to make it stand up and display or close it to put it in your pocket??
Kenneth Loebenberg
My fear with splitting those was how small the parts would get. Especially for the FDM folks
AC-3D.Caen
Great work But : cascade, pokeball, rainbow and earth (the nightmare) need to be split or be sure to have the paint job skill ...
