hutska
patreon
First Edria print pics
🕑 Added 2021-10-21 16:41:48 +0000 UTCThe print is done, it turned out alright, but there is many things i need to fix and polish.
Took about 14 hours in total to print. Head, upper body, lower body and tail were in seperate parts.
I need to adjust the connection points, as they did leave kinda noticable gap and seam. My biggest mistake was that I did very heavy supports, which left nasty marks on the backside upon removal. This was though first time doing them, and wasn't sure how was needed.
I will print again, but adjust and fix those bits.
All in all, when not looking it at less than 20cm distance, it does look fine and dandy.
Comments
Pal Kia
Just be careful if you comeback tomorrow and notice it several centimeters taller~
AlexFenFox
This looks fantastic! :3
MadMutter
Amazing! Thanks a lot for the update. For a first print it turned out amazing! I absolutely love this. I really need to get into the whole 3D printing game.
Salsabubble
This is not just fine and dandy >:O This looks amazing! <3
