Torrida Minis
patreon
Queen of Blades wip03
🕑 Added 2025-02-19 00:11:43 +0000 UTCHello!
Wow, this was a productive day! I posed my Queen of Blades model, and then I managed to add the whole creature as well. I stopped all my side gigs to properly handle this figure, and I hope the results will be worth the effort.
I must admit that I wasn't very excited with this character, because it's very unlike most of the stuff I make here, but I have to say that I'm enjoying it quite a lot, precisely because it's something fresh. Besides, it's been a while since I don't have the chance to work on a creature, and the challenge is nice.
Tomorrow I hope to tackle the base, and then I'll begin the 3D printing preparations. I may need to make some complex cuts to the model, as it's going to be a big one to print, no matter the size of your printer.
My Queen of Blades model will be released on March 2, 2025.
Comments
Torrida Minis
Thank you for the feedback, once again. I'm trying to adjust a few things in the pose also based on your image, and I hope I can at least improve it a little bit.
Torrida Minis
Oh, that's a pity. It's a bit too late to change the pose now, but I'm trying to tweak a few things to give it a bit more weight, at least.
SayoSaHa
These are my thoughts right now. You can take it or leave it, but I think the side view is looking a bit wonky atm because of the way her upper body is leaning way to the back without anything to support her upper back. From the front, it's looking great, though. https://imgur.com/a/4QrMpjF
Sketch3D
Thank you for your efforts! It's very appreciated! Looking forward to see the final results and test print her.
Max
I like the design, but pose is very stiff.. and kinda boring :S
Johnathan Blanco
Oh ok , that level of detail is amazing can’t wait to see the final result
Sam
Looks awesome man
