Il_Paddyy
patreon
Cha hae last wip and scale question!
🕑 Added 2024-05-21 16:02:25 +0000 UTCHi guys, last update on the model. Just a few little details here and there to finish, but I'm practically done. I'll take the next few days to refine the model and start preparing the fittings!
But I have a question for you, since I'm always asked what scale the model is. How tall would you like it to be? And what scale would that correspond to?
Thanks everyone, I hope you like it!
Comments
Il_Paddyy
Oh thank you, i'll try it!
Pipoxo
Your skull knight and most chainsaw man models you’ve released have been in 1:8 scale. Personally I don’t care what scale they are at as long as they’re in a specific scale so its easier to re-scale. I use sanix’s scale converter tool is very helpful ( https://sanix3d.com/scale-converter-page/ )
Il_Paddyy
jin woo if I'm not wrong it should be around 24 cm, because the whole model including igris is 32, so yes more or less 24...
Il_Paddyy
Ok thanks everyone
Daniel
What scale was Jinwoo? I haven't had the chance to print him yet
Marcio Chuang
i think you should keep same as sung jin woo.
patrick frani
Like what nono said, keep it consistent with your Jin Woo. But I mostly print in 1:6 scale 🙂
Tsz Sui Lo
I concur. I also print at 1/6 99% of the time. Since scale is relative, you just have to take the height of the percent and find multiply that by 1/6.
Daniel
I print most of my models in 1:6 scale. For me, it's the perfect compromise between space and having good detail. Cha's height is said to be between 160-170cm which would put her height at 1:6 around 26.6-28.3cm not including the base.
Nono
Like Sung Jin Woo, like that it's consistent :)
