Geoffro
patreon
Tie Executioner Update needed
🕑 Added 2018-05-13 01:25:27 +0000 UTC Hi Everyone, this is a very quick note to say if you haven't printed the Tie Executioner helmet yet, I would hold off.Adam has finished one, sanded painted etc and we both agreed that the front really needs a bit of work on the accuracy side of things. I do sincerely apologize to anyone who printed it and was not terribly happy with the accuracy. I tried to make it a one piece print at the front to make things easier, but turns out all that did was raise the nose section and make the "teeth" as I call them, or the 6 spines leading up into the nose.. too prominent in the bottom corners near the cheeks.
If it was something really small, I probably wouldn't worry so much about it but the more I see it the more its buggin me! so please just hold off printing this one for a week or so, I need to get a couple bits added for the Boba fett suit (the foot spikes) and really want to have 1 of the 3 Vader helmets finished by the end of this week.
Happy mothers day to all the Mums out there, we know its a tough job!
Comments
Rafael Acevedo
Thank you sir!
Geoffro / Hex3D
I will send you a temporary link to level 2 now. I have been working on making the storage system here a little more secure, almost done with it.
Rafael Acevedo
Geoffro - where are the links for the members? I joined a week or so ago but can't find any models and none of the links I have found work. I am sure it is operator error but could you point me in the right direction? Thanks!
