Geoffro
patreon
Flame Trooper Back/Tank Pack
🕑 Added 2019-01-28 08:55:49 +0000 UTC*Files can be found in the Member Depot*
I held off on making this one for a while, but now that its done the flame trooper costume only needs one more part and thats the actual flame thrower which I will do soon.
This is not a hard print, there is just over 50 parts to print, but there are a couple of things to note.
1. The Main large tanks are 30cm tall, if you want to print them on a smaller machine you will need to cut them further.
2. Part 21 is the piece that will attach to the FlameTrooper suit back torso. Right now it is a blank slab, but it is to be updated. It is a small/easy part to print that can be inserted at any point in the assembly, including at the very end. I will be updating Part 21 as soon as the new updated flame trooper costume is finished (with now uncut parts) along with the flamethrower.
Comments
Geoffro / Hex3D
its not in there, new one coming.
ShadyP
I'm not seeing the rest of this suit in the level 3 dropbox. Is it in there?
adam
So much to print and sooo little time!
