Geoffro
patreon
T800 Factory Press V1 1:12 /6" Figure Scale
🕑 Added 2020-05-04 05:19:39 +0000 UTCEdit - very sorry for the file messup, just a tired mistake at 4am... have fixed and reuploaded
Since posting images of this i've been sent several other types of these dioramas and will make some more versions as time allows, but will upload this one at least for now. The Arnie insert measures 15.3cm high or approx 6" / 1:12 scale figure height.
Printing notes:
Infill % is up to you but Supports are required for the hinges.
Part 3 /4 the Top piping may be printed without any support, they have no islands but a few sharp angles but honestly I would print them without supports and print slow so the pipes don't get too messy.
Comments
Peter Richards
Is anyone else getting that optical illusion where it looks like the mould is bulging out instead of sinking 'in'?
Peter Richards
Hope you can get some sleep. The homeschooling/lockdown/work weirdness makes sleep tricky.
Geoffro / Hex3D
Bad Files removed, re-uploading the fixed now, sorry I just had zipped up the wrong set of files (the unrepaired unscaled ones) just tired :/
