Geoffro
patreon
Plague Doctor Mask V2
🕑 Added 2020-07-26 07:58:55 +0000 UTCForgot to add this one to the archive, this is a new mask obviously based on the old one but with a few changes, there is new eyes, new eye placements, stitching doesn't fade out at the nose, new lenses and its sized more appropriately to fit a normal head of someone around 170-180cm tall.
Enjoy!
FILES:
Has been added to the Member Depot along side the Plague Mask V1
https://www.hex3dpatreon.com/viewtopic.php?f=295&t=255
Has also been Added to the Starter Pack section for new members
:
https://www.hex3dpatreon.com/viewtopic.php?f=25&t=256
Comments
Antworm
What would be the easiest way to slice this model in 2? I’ve never sliced anything before but would love to print this mode
Patrick Devine
Tall is fine I split the model in 3d builder, it's the mask part over the face, hangs out just a little too far. If I shrink it a little it slices fine. But I need to know if 95% is too small, as it's a 2 day print.
Geoffro / Hex3D
This is too tall yes you could lay it on the plate as you would wear it and then only shrink the Y axis (jus make sure uniform scale isnt ticked) and you can easily knock 2-5cm from the length without making it look too squished
Patrick Devine
the face part seems to be just a little too big for the Ender 3 build plate. How much can i shrink the mask before it might be too small? would i have issues printing at 95%?
Dante Nava
WOOHOO!!!!! Thanks Geoff!!! Oddly enough, in the US, they just had a case of Bubonic plague the other day.
