gamescape3d patreon

November Preview 3, some done, some wip

🕑 Added 2020-10-23 17:49:01 +0000 UTC

Comments

It's no problem, I'll put them out both ways. Yeah it can help a bit since it is almost a z axis print stood up. I find the ring lines can really kick in hard on roofs with a modest pitch , sometimes it is even worse than flat parts with texture. But I haven't tested it with this specific texture.

Brent Winters

I have an FDM printer and all the roofs from other sets I've printed were one piece. I didn't know quality would improve in two pieces. I guess because the angle is changed?

Yes, I agree we'll probably start to see a lot more people willing to mix with these cheap mid size resin printers coming out and it doesn't really take much skill to figure chitubox supports and hollowing on buildings compared to dynamic poses on some miniatures.

MTGandMORE

offering both will be good, since the first thinh i thought was : het you can print those in resin for once :D

NickyBHobbying

All the different colors

Thanks Mario:)

I don't mind offering it as an optional DL, it will be good for laser sintering or resin printers out there. It won't be good for fdm printers though, they'll be trading the seam for salmon skinning and less detail.