BriteMinis
patreon
February post No. 1
🕑 Added 2022-02-10 23:57:40 +0000 UTCMy brain is out of creative spirit right now, so no short silly story accompanying this release. But I have a competition for you - write a short, one paragraph (max 3-4 sentences) story in the comments including all these four characters and add a fifth of your choice, and in one week I'll pick one story I fancy the most and will turn that fifth character into a mini in releases later this month.
So here are more supportless minis for you based on your suggestions:
- MOAR PIGFACE archer
- paladin/crusader on foot
- flameskull
- rogue/thief
Get them in the repository (new link!), the crusader goes to Thingiverse and PrusaPrinters.
Thank you for your support!
next: Moar picks from your suggestions.
Comments
Beholder.Madness
With or without base? Are you using a brim/raft? What kind of plate (glass/flex/etc)? What speed are you printing at? What is your travel speed? Sorry for so many questions. There are so many things that can cause this. If the entire print is coming off of the plate, there might be bad bed adhesion (maybe try a brim or a raft). Another way around this is to turn on Z-hop (this will lift the nozzle before a travel, but might cause extra stringing).
The Nozzle is knocking the print off of the build plate. I keep adjusting but cant seem to get it right. Never happened before with any of your prints. I am sure it is not an issue with the file.
Brite Minis
FDM print? What exactly happens?
Mine keeps failing about mid-way though print.
